The GIOTTO series surface wall-mounted monitor in ABS is supplied with a fixing bracket with terminal Elvox Two-Wire audio/video door entry systems. CN1). Connector for electronic unit. CN2). Connector for programmer type C. B2). 2-wire Bus (cable riser). B1). 2-wire Bus (cable riser). EXT+). External. Elvox Sound System Installation and Technical information 5 12 GIOTTO AND SERIES MONITORS ® GIOTTO SERIES MONITORS.
|Genre:||Health and Food|
|Published (Last):||23 April 2006|
|PDF File Size:||10.5 Mb|
|ePub File Size:||19.63 Mb|
|Price:||Free* [*Free Regsitration Required]|
Once the short circuit has been eliminated,wait for a few minutes to allow the protection device to cool down so that the unit can return to normal operation. The entrance panels can be coupled with the button-only series directly in the factory.
4.0″ SURF. B+W MONITOR—WHITE
For systems without coaxial cable, input for connection of the V2 signal. The figure shows the connection of an entrance panel with the speech unit only and a separate camera type – 5A20 – 5B20 -5A 5B10 – 5C In position “0” ringtone OFF terminals 7 – 10 are connected to the diode, thus enabling the red visual indicator LED to light.
The switchboard only can be called and can converse with an entrance panel and activate the electric lock. Power supply type powers a single monitor type Wiring diagram of 3600 entrance panels with camera type 63U7 or 63B7 and switching module type W.
Eelvox may also be used separately with the correct accessories. To communicate from the switchboard to the interphones, lift the interphone of the switchboard, activate the line selector key and press the CH button. Elvox have recently introduced their series front panels.
Alpha Communications™ ” SURF. B+W MONITORWHITE
Wiring diagram for video floor distributor F3A V F1 fuse. Elovx generator output with continuous tone. It is possible to connect an entrance panel with the speech unit only and a separate camera type – – 5A20 – 5B20 5A10 -5BC To make a call from the interphones elvos the switchboard, simply lift the interphone of the interphone; the switchboard will signal the call by lighting up the LED for the interphone and activating the internal electronic ringtone.
To communicate with the speech unit, the user must press the push-button marked until the end of the conversation. Power supply 15V D.
This type of system does not allow conversation privacy. TYPE Desk-top conversion kit for combined interphone typetype and monitor typetype Amplified audio door entry system. 63000
Wiring diagram of apartment landing call button Open voice audio door entry system with interphones type Wiring diagram of separate camera Standard wiring diagram variations 9, 10, 11, 12, 13 and The switchboard can call or be called by all the users. Power supply 12 to 20V D. Sound circuit supply Intercommunicating C1: Screen with horizontal lines: Monitors to be used on this elfox are type, This elvos also makes it possible to use a single loudspeaker built into the interphone itself to produce the sound.
Cameras and audio speech units for entrance panels The installation is equipped with conversation privacy: If you do not wish to connect all the interphones, follow the instructions indicated below.
Video door entry system with two video speech units and switching module type Interphone type type V1 M V2 M V3 S Use additional push-button No 1, e,vox as shown in the diagram, to enable opening of the door lock after a call, with the interphone ON. In the event of buzzing on the audio line, move the switching module “A-B” 630 under the cover to position “A”.